IFA-80 AL Cooktop pdf manual download. BURNER SIZE AND CONTROLS 50 W to 2000 W ” 50 W to 2800 W 50 W to 2000 W 4.2 CONTROLS AND OPERATION POWERING ON Press the.
IFA F9 Car | |
---|---|
Overview | |
Manufacturer | Automobilwerk Zwickau Automobilwerk Eisenach |
Production | 1949 –1956 |
Body and chassis | |
Body style | 2 door saloon 2-door cabriolet 3-door estate |
Powertrain | |
Engine | 910 cc two-stroke straight-3 28 / 30 bhp |
Transmission | 4-speed manual |
Dimensions | |
Wheelbase | 2,350 mm (93 in) |
Length | 4,200 mm (170 in) saloon |
Width | 1,600 mm (63 in) saloon |
Height | 1,450 mm (57 in) saloon |
Curb weight | 820 kg (1,810 lb) (empty) |
The IFA F9 was a compact saloon manufactured under the auspices of the Russian and East German states between 1949 or 1950 and 1956. It was initially built at Zwickau at the plant previously owned by Auto Union. In 1953 production was transferred to the former BMW manufacturing plant at Eisenach where its underpinnings subsequently found their way into the Wartburg 311.
Origins
Mechanically the F9 derived from the DKW F8 which had been available between 1939 and 1942. The body closely followed the design of the DKW F9, a prototype with which Auto Union would have replaced the F8 on the Zwickau production lines earlier, had the war not intervened. After the war, the first car assembled at Zwickau was the prewar DKW F8, but the more modern F9 started to appear in 1949 or 1950 (sources differ). Materials shortages probably delayed introduction in both German states, but the eastern car beat the western to the market, and certainly featured the three-cylinder motor from the 1938 F9 prototype (rather than the two-cylinder motor that had been in serial production in 1942) at least three years before Auto Union in Düsseldorf were installing it in their F91.
- Ifa W 50 Manual If you are searching for the book Ifa w 50 manual in pdf form, then you have come on to the right site. We furnish utter variant of this ebook in PDF, doc, txt, ePub, DjVu formats. You can reading Ifa w 50 manual online either load. In addition, on our site you may read the manuals.
- IFA F9 IFA F9 Car Overview Manufacturer Automobilwerk Zwickau Automobilwerk Eisenach Production 1949 –1956 Body and chassis Body style 2 door saloon 2-door cabriolet 3-door estate Powertrain Engine 910 cc two-stroke straight-3 28 / 30 bhp Transmission 4-speed manual Dimensions Wheelbase 2,350 mm (9.
- The IFA W 50 is a medium-duty truck built by the East German IFA conglomerate at their Ludwigsfelde plant from 1965 until 1990. A total of about 572,000 were built in Ludwigsfelde, with an unknown additional number of special-use vehicles assembled at other plants. It was meant to be succeeded by the IFA L 60 but outlived it by several months. IFA ended all truck production on 17 December 1990.
The bodies
Surviving F9s appear largely restricted to saloon versions, but various sports and cabriolet versions were also produced. Steel for consumer industries was in short supply across many parts of Europe during this period, and the F9’s body construction increasingly involved plastic panels, especially after production was moved to Eisenach in 1953. The car was accordingly usefully lighter than its western built Auto Union equivalent.
Technical
The F9 featured a three-cylinder two-stroke water-cooled engine of 910 cc with a claimed output, at launch, of 28 bhp (21 kW). The engine was water-cooled, the radiator being located behind the engine, an unusual configuration but one also found on the DKW F91. The front wheels were driven via a four-speed manual gear box with a free wheel.
40663 produced .
Related
About
Updated
Published date
IFA W 50 | |
Overview | |
Manufacturer Schweizer 300 maintenance manual. |
|
Production | 1965–1990 |
Body and chassis | |
Body style Forte agent 8 serial. | truck |
Powertrain | |
Engine |
|
Dimensions | |
Wheelbase Idm setup crack. |
|
Length | 5,300 mm (210 in) |
The IFA W 50 is a medium-duty truck built by the East German IFA conglomerate at their Ludwigsfelde plantfrom 1965 until 1990. A total of about 572,000 were built in Ludwigsfelde, with an unknown additional number of special-use vehicles assembled at other plants. It was meant to be succeeded by the IFA L 60 but outlived it by several months. IFA ended all truck production on 17 December 1990, following the reunification of Germany.
History
Beginning in the late fifties, the Kraftfahrzeugwerk 'Ernst Grube' Werdau began work on a truck designed to replace the outmoded IFA W3 and S4000-1 models. Work progressed slowly, as the company had limited resources but had to respond to input from a number of political groups, including but not limited to the Moscow-based Comecon, the National People's Army, the Berlin Planning Commission, and General Secretary Walter Ulbricht himself. The truck was to have a cargo capacity of 4 1⁄2 tonnes (9,900 lb) while being able to take a variety of bodies, all-wheel drive and three axles had to be an option, production had to be simple, and it had to use a standardized engine. Originally called the S4500, the name changed to W 45 in 1959 ('W' for 'Werdau'). The first prototype (W 45LF) was operational in June 1962, with the four-wheel drive W 45LAF following shortly thereafter. It was expected to enter production in the last quarter of 1964, but then the requirements were increased to 5 tonnes (11,000 lb) and the design was renamed the 'W 50 - Wstands for 'Werdau' and 50 represents 'five tonnes'. However, on 21 December 1962 the Ministerrat der DDRdecided that the VEB Industriewerke Ludwigsfelde (IWL) would build the W 50 instead of Werdau. One of the reasons for this decision was the cancellation of Dresden 152 airliner production in February 1961, which had caused the end of Pirna 014 jet engine production at Ludwigsfelde .
Construction of a new truck factory at Ludwigsfelde began in April 1963. The site covered 170 hectares (420 acres) and the production hall complex was the largest in the DDR, with a floor area of about 130,000 m2(1,400,000 sq ft). The building extended 400 m (1,300 ft) in each direction, was 15.6 m (51 ft) high and the span between each of its steel columns was up to 24 m (79 ft). IWL completed the first W 50 truck on 17 July 1965, several months before the end of Troll 1 scooter production that December.
W 50 truck production rose rapidly from 5775 in 1966 — the first full year of production — to 16,973 in 1969.However, serious quality problems arose with the W 50. IWL was working on the development of future truck models, but in August 1969 it had to stop such work to devote the entire capacity of its development and construction offices to tackle them. IWL's efforts to develop new trucks were divided again in 1971, when the most urgent needs were to improve the W 50 with a new cab, new 180 bhp engine and better chassis. After 1969 W 50 production growth was slower but set a new record almost every year, peaking at 29,004 in 1982 and again at 32,516 in 1986.
A high proportion of IWL trucks was exported. Between 1978 and 1987 over 80% of W 50 trucks built each year were sold abroad. The DDR needed export orders from countries outside the Comecon bloc, and for this IWL continued to develop variants of the W 50. As a result of the 1980–88 Iran–Iraq War, both Iran and Iraq sought a simple, robust, inexpensive truck for their armies. The DDR was interested in supplying both sides in the war, so in March 1982 IWL began development of two derivative models, the IFA W 51 and W 52. The W 51 was meant to enter production in 1983, followed by the W 52 two years later. Part of the W 51 project was realised, but the W 52 was overtaken by an SED Politbüro decision in June 1983 to instruct IWL to concentrate on W 50 assembly and gradually displace it with its intended next-generation successor, the L 60. Total W 50 production at Ludwigsfelde from 1965 to 1990 was 571,831 vehicles, some sources state 571,789.
Design
Built on a 3.2 m (10 ft) wheelbase, a plethora of different versions (about sixty different models were available directly, with other firms able to produce special versions) were developed over the years. Two wheelbases were available, 3.2 and 3.7 m (10 and 12 ft). Right-hand-drive models were built for export and for special uses such as street sweeping. The W 50 was also popular with fire departments, especially as the LF16 TS8 pumper, and many examples are still in service in the former East Germany.
As required by the original brief, however, the engine was standardized: for the first two years, it was a revised version of the unit used in the IFA S4000-1: the 110 PS (81 kW) swirl chamber diesel was called '4 KVD 14,5/12'. In 1967 a direct injection version of this diesel four-cylinder replaced it. As with the earlier version, the '4VD 14,5/12-1 SRW' displaces 6.56 L (400 cu in) but here it produces 125 PS (92 kW) at 2300 rpm. The engine was built by VEB IFA Motorenwerk Nordhausen in the eponymous town. After 1973 the slightly modified '4 VD 14,5/12-2' replaced it. The new version was a better cold starter and remained operational in temperatures down to −40 °C (−40 °F), as per the requirements of the NVA.
Hungarian bus manufacturer Ikarus also manufactured a rear-engined midibus called the 211, which used a variety of W 50 parts including the engine and axles. It was built from 1976 until 1990, when the demise of the W 50 meant that it had to be discontinued.
Replacement Proficy machine edition serial.
After the launch of the W 50, IWL undertook development work to increase engine power and reduce fuel consumption, reduce empty weight and increase payload, improve reliability and driver comfort and reduce production time. From 1967 IWL was planning a range of new trucks with sizes of three, five, six and 10 tonnes. Two prototypes were built: a three-tonne truck code-numbered 1013 followed by an 11-tonne one code-numbered 1118. After a protracted development, the 1118 became the IFA L 60, which was originally intended to have a Volvo cab. In the end, the L 60 was given a cab based on that of the W 50, but able to be tilted forward for access to the engine. The L 60 was finally unveiled to the public at the Autumn Leipzig Trade Fair in September 1986 and its series production began at Ludwigsfelde in June 1987, twenty years after development work had begun. As a result of slow sales of the L 60, IWL kept the W 50 in production alongside the L 60 until 1990.
Related
About
Updated
Ifa W50 Manual Instructions
Published date